ESAB MultiPower 460 Pulse Instructions d'exploitation télécharger pdf (Page 9)

SECTION 1 DESCRIPTION

Figure -1 MultiPower 460Pulse Control Panel

I. SAFETY

Before the MultiPower 460 Pulse Control Panel Kit is installed, the safety

section at the front of this manual should be read completely. This will help

avoid possible injury due to misuse or improper installation.

The definitions relating to the:

safety notations are described at the end of the Safety Section in the front of

this manual — read them and their specific text references carefully.

II. DESCRIPTION

This manual has been prepared for use by an experienced operator. It

provides information to familiarize the operator with the design, installation

and operation of the MultiPower 460 Pulse Panel. DO NOT attempt to install

or operate this pulse option until you have read and fully understood these

instructions. The information presented here should be given careful consid-

eration to ensure proper installation and optimum weld performance.

The MultiPower 460 Pulse kit upgrades a standard MultiPower 460 power

source to a multi-process power source designed for Mig short circuiting,

spray and pulse spray transfer (GMAW), flux core (FCAW), Tig (GTAW), and

stick (SMAW) welding and air carbon arc cutting/gouging (CAC-A) applica-

tions. The following instruction assumes you are familiar with the standard

MultiPower 460 operation and set-up. These instruction are intended to

supplement the original MultiPower 460 instruction book received when the

power source was installed.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Pas de commentaire

ESAB MultiPower 460 Pulse Instructions d'exploitation Page 9