ESAB MultiPower 460 Pulse Manuel d'instructions télécharger pdf (Page 45)

SECTION 5 MAINTENANCE

Table 5-1. Troubleshooting Guide

CONDITION ACTION

Unit Inoperative

No input power. Check main line (user’s) switch fuses -- replace if

needed.

Poor or improper input (terminal board) connections.

Defective on/oﬀ switch -- replace.

Thermal light on. Main transformer overheating. Also check for prop-

er cooling, proper primary hookup, or shorted turn on secondary.

Loss of primary phase. Find & replace defective fuse.

READY/ ON Light is OFF See Figure 5-2

Fan Does Not Run See Figure 5-3

(READY Light is ON)

No Output -- Fan Running

Poor or improper electrical input -- check input connections on TB.

Poor connections at output terminals/work station -- check, tighten

or replace.

Main transformer overheating -- thermal switches tripped due to re-

stricted cooling air. Temperature light on front panel will be lit. Let

unit cool down.

PC board defective or loose PC board connector(s) -- if loose, reinsert;

if defective, replace.

No Output - STICK Position See Figure 5-4

Meter Display is Blank See Figure 5-5

Preset Does Not Function See Figure 5-6

Ammeter Displays 760 Amps See Figure 5-7

Limited Output or

Low Open-Circuit Voltage

Input voltage jumper links on terminal board improperly set -- check

for proper voltage.

Poor output connections. Take apart, clean, and reassemble.

Panel-Remote switch in Remote position and remote voltage pot dis-

abled.

Over Temperature Light is ON See Figure 5-8

Erratic Weld Current

Welding cable size too small -- use correct cables.

Loose welding cable connection (will usually get hot) -- tighten all

connections.

Improper wire feeder setup.

PC board defective -- replace.

High Output, No Voltage Control

PC board defective or loose -- reset and/or replace board.

Shorted I.G.B.T. - Replace I.G.B.T. and check driver PCB.

No 115 Volt ac Output

Circuit breaker tripped. Check 115V CB2 -- Reset.

Line Fuse Blows When Power

Source is First Turned On

Shorted DIODE in Main Bridge -- replace.

Shorted capacitor in Capacitor Bank.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 68 69

Commentaires sur ces manuels

Pas de commentaire

ESAB MultiPower 460 Pulse Manuel d'instructions Page 45

Commentaires sur ces manuels

Produits connexes et manuels pour Système de soudage ESAB MultiPower 460 Pulse