ESAB MultiPower 460 Pulse Manuel d'instructions télécharger pdf (Page 32)

F. PULSE PARAMETERS

Tables 4-3 through 4-8 list the approximate pulse weld parameters for each material

and diameter available. These are provided for general reference only. Actual pulse

parameters can vary with the equipment set-up, welding application and shielding

gases being used. The wire feed speed ranges shown in the tables are the same

as programmed into the Multipower 460 Micro. Attempting to weld outside of the

suggested speed ranges will result in a "blinking" warning light on the Multipower

460 front panel. A "steady" light on the panel indicates the wire material and

diameter combination selected does not have any pulse data programmed.

SECTION 4 OPERATION

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 59 60

Pas de commentaire

ESAB MultiPower 460 Pulse Manuel d'instructions Page 32